English translation for "double arcing"

双弧现象

Related Translations:

arc out:  沿弧线后拉

arc segments:  扇形块

behind arc:  弧后

stationary arc:  稳定弧光

conjunct arc:  联合弧

scotia arc:  斯科舍岛弧

diffraction arcs:  衍射线

goniometer arc:  测角器分度圈

arc cathode:  电弧阴极电弧阴级弧光放电阴极

arc brazing:  电弧钎焊电弧铜焊电弧硬焊弧铜焊

Example Sentences:

	1.	The parameter design of double arc gear based on pro e 的双圆弧齿轮参数化设计的研究
	2.	Reliability analysis of bending fatigue strength for double arc gear 双圆弧齿轮传动弯曲疲劳强度可靠性分析
	3.	The numerical results show that the double arc transition form can make different cylinder shells eliminate stress concentration at two ends and amend stress distribution of changeover portion 计算结果表明：双圆弧式的过渡形式能使不同直径圆柱壳两端连接处消除应力集中和改善过渡段应力分布。
	4.	Our products are matched with electric hammer machines of bosch , aeg , black decker , hilti , phillips , hitachi , and makitak etc . the petiole is cylinder with double arc and groove 本公司的产品与bosch aeg black decker hilti phillips hitachi makitak等公司电锤机配套。柄部为带双圆弧双键槽的圆柱体。
	5.	Static and dynamic contact calculation model for double arced gear was established based on finite element soft ware ansys , and a number of items that ought to be paid attention to on the calculation of contact stress and strain of gear under real operation condition were discussed 摘要基于有限元软件ansys建立了双圆弧齿轮静态和动态接触的计算模型，讨论了在真实转动情况下计算齿轮接触应力、应变应该注意的一些事项。
	6.	The influence law of gear ' s bending stress affected by nominal pressure angle and technological angle of tooth profile has been summarized and obtained a conclusion that the maximum bending stress before running in period occurred at the waist place of the tooth , thus provided a theoretical foundation for the design and application of double arced gears 总结了名义压力角和齿形工艺角对轮齿弯曲应力的影响规律，并得出跑合前最大弯曲应力发生在齿腰处的结论，为双圆弧齿轮的设计和使用提供理论依据。
	7.	In order to approach the optimum design of changeover portion structural shapes for submarine ' s different diametral pressure cabins , a new structural type , named the double arc transition form , is introduced based on the analysis of stress concentration , by using the engineering calculation method and finite element mthod 摘要为了探讨潜艇不同直径的耐压舱室过渡段结构型式的最优设计，利用工程计算方法和有限元方法，分析过渡段结构的应力集中，提出了能够使不同直径圆柱壳光滑过渡的结构形式双圆弧式过渡形式。

Similar Words：

"double arc-melting" English translation, "double arch bridge" English translation, "double arch dam" English translation, "double arched dorbel-table" English translation, "double archway" English translation, "double area system" English translation, "double arm" English translation, "double arm bar to pancake" English translation, "double arm clasp" English translation, "double arm drag" English translation